|
   
Adjusting and Reversing the
Fence is simple! To adjust the fence closer
to or farther from the blade, loosen the two fasteners on the
rear of the fence. Then position the fence exactly where you
want it and tighten the knobs. To reverse the
guide for use on the other side of the blade, simply
remove the two fence fastening knobs (fig.1) and the fence
attachment plate (fig.2), slide the index bar out of its
track, then simply reattach the telescoping arm to the other
end of the fence attachment plate (figs.3&4) and replace
the knobs.
|
 |
In this
semi-transparent illustration you can see how the connection
between the riser and the red extrusion is off-center on the
cylindrical riser. A hex key is inserted down through a hole
in the top of the red extrusion to loosen the connecting
shoulder bolt. Then, by rotating the black riser, the entire
extension arm assembly can be precisely adjusted as you see
fit to plus or minus exact zero. |
